I've received the description for the cable, as well as the 
following *** W A R N I N G *** by Mail.

Firstly, the warning:

I was just looking at your site and come upon the simple serial cable.
Without thoroughly checking which pin goes to where I suspect that this
configuration could potentially damage the PC-E500.
The IBM -PC outputs plus and minus 10 volt signals on its RS232 connector.
The logic levels of the PC-E500 are 0Volts and 5 or 6 volts.
If voltages above the supply voltage (5 or 6 volts) or below ground
are input into the PC-E500 inputs damage could occur to the input
chip.

In the file pc-link.tar.gzip, the file rs232-12.doc and rs232-12.txt
are the same file with different names.  If you feel so inclined, one could
be deleted.

If I find anything else I'll let you know.

				Andrew Woods


OK, If you do not believe him, you may have a look at the setup, but
BE CAREFULL AND ONLY TEST IT, IF YOU ARE ABSOLUTELY SURE!!! (Sorry I
can't say anything, because my knowledge in ElectricalEngineering is 
nearly -\infty!)

If YOU have any idea and suggestions, please mail me immediately!!!!

AGAIN: I'VE GOT A MAIL, THAT THIS SETUP COULD DESTROY YOUR COMPUTER!
####################################################################


SHARP (15 pin)         PC (9 pin)
2			2
3			3
11			6
5			4
7			5
		      / 7 (these should be 
		      \ 8  connected together)

THERE COMES **NO** GUARANTEE WITH THIS SETUP!!!